Design your own fish shoal

Handmade to order

Fittings included

Mix and Match

Three colourways:

Bronze & blue

Dark Blue & White 

Light Blue & white

Three sizes:

Large: 25cmx9cm

Medium: 21cmx8cm

Small: 127cmx6cm

Fitting Fish:
Fish comes with pre-drilled eye-socket

Step 1

Place Bolt in hole as eye, put washer on bolt at back of Fish, tighten nut on bolt till bolt is tight to Fish, loosen by half a turn

Step 2
Wall:
Drill hole (8mm) into wall, put wall plug in wall. place bolt end of fish into raw plug, screw (clockwise) the bolt slowly into the wall plug until it is the ‘height’ from wall you wish. The fish will revolve as nut on back not fully tightened yet.

Wood:
Drill hole (6mm) into wood, place bolt end of fish into hole, screw (clockwise) the bolt slowly until it is the ‘height’ from wood you wish. The fish will revolve as nut on back not fully tightened yet.

Step 3

Put correct Spanner onto bolt on back of fish and use screwdriver to tighten from eye on front of fish to tighten onto fish, fish can then be revolved into place.

Any problems please contact allen@roardesign.com